|
|
Charge Controllers for Solar Panels |
(Click to Enlarge)
|
Sunsei 10A controller (CC10000)
Highly reliable 12V, 10A charge controller, part of the Sunsei range. It will efficiently charge your batteries and provide years of protection from overcharging, prolonging your battery life and reducing maintenance requirements.
* Simple, rugged electronics. A low component count and 100% solid state control functions make this a highly reliable controller.
* Features two stage charging boost and float charge using pulse width modulation (PWM)
* Status LED indicates battery charging
* Reverse leakage protection prevents power loss at night
* Terminal Block. For sound and easy wire connections
* 57x70x28mm, 0.12kg.
UK Delivery £3.95
|
| |
(Click to Enlarge)
|
ASC20W controller (No LED)
Uses less than1/10th the power of the industry average. The zero battery consumption at night saves lots of power, especially in systems that get covered in snow or need to last through prolonged overcast conditions. Almost all other charge regulators have a standby current draw that will drain the battery during poor light conditions.
* Perfect for telecommunications, solar
powered parking meters and other small PV
systems up to 20W.
* Save up to 10% of the power from a 5 Watt
module.
* Protection (PV & Battery), against short-circuit
& reverse polarity, overload, over temperature
& battery removal
* Can charge a completely discharged battery
* Extreme design
* Series design (not shunt)
* Reliable - 100% solid state
* No radio interference
* LED indicates charging
* Wall mountable ABS plastic case
* Fully encapsulated in epoxy potting
* Dimensions: 3.8 x 7.0 x 3.1 cm; 34g
* Battery consumption zero, 0.0 mA
* Typical solar consumption 5 mA daylight only,
1 mA without LED
* 5 year warranty
UK Delivery £3.95
|
| |
(Click to Enlarge)
|
P3 folding panel controller
12V, 7A controller for use with P3 folding solar panels up to 55W. LED indicators show charging or full. 9.21 x 6.35 x 2.54cm
UK Delivery £3.95
|
| |
(Click to Enlarge)
|
ASC20W controller (with LED)
Uses less than1/10th the power of the industry average. The zero battery consumption at night saves lots of power, especially in systems that get covered in snow or need to last through prolonged overcast conditions. Almost all other charge regulators have a standby current draw that will drain the battery during poor light conditions.
* Perfect for telecommunications, solar powered parking meters and other small PV systems up to 20W
* Save up to 10% of the power from a 5 Watt module
* Protection (PV & Battery), against short-circuit & reverse polarity, overload, over temperature & battery removal
* Can charge a completely discharged battery
* Extreme design
* Series design (not shunt)
* Reliable - 100% solid state
* No radio interference
* LED indicates charging
*Wall mountable ABS plastic case
* Fully encapsulated in epoxy potting
*Dimensions: 3.8 x 7.0 x 3.1 cm; 34g
* Battery consumption zero, 0.0 mA
* Typical solar consumption 5 mA daylight only, 1 mA without LED
*5 year warranty
UK Delivery £3.95
|
| |
(Click to Enlarge)
|
Sunsport 6-6Amp Solar Charge Controller
Automatic nighttime shutdown with an intelligent design means that in the dark the Sunsport 6 uses absolutely zero power. Ideal for PV systems where efficiency is important. Boaters can leave it connected all winter without draining the batteries. Other controllers, which have a standby current draw, will drain the battery over the winter if they receive little or no solar input.
* Stylish design with many features.
* Save up to 10% of the power from a 5 Watt module.
* Protection (PV & Battery), against short-circuit & reverse polarity, overload, over temperature & battery removal
* Can charge a completely discharged battery
* Regulation method: Low frequency On-Off series; Typical set points: Off: 14.1 Volts On: 13.3 Volts
* Extreme design
* Series design (not shunt)
* Reliable - 100% solid state
* No radio interference
* LED indicates charging
* Wall mountable; stainless steel mounting screws provided
* Solid aluminum case, completely sealed in epoxy potting
* Dimensions: 6.4 x 9.6 x 1.8 cm; 210g
* Battery consumption zero, 0.0 mA
* Typical solar consumption 8 mA daylight only, 3 mA without LED
* 5 year warranty
UK Delivery £3.95
|
| |
(Click to Enlarge)
|
Sunsport 10-Dual Battery Solar Charge Controller
Marine option specifically designed for boats charges two isolated batteries from one panel. Completely sealed for protection from the harsh salt water environment.
Automatic nighttime shutdown with an intelligent design means that in the dark the Sunsport 10M uses absolutely zero power. Ideal for PV systems where efficiency is important. Boaters can leave it connected all winter without draining the batteries. Other controllers, which have a standby current draw, will drain the battery over the winter if they receive little or no solar input.
* Many innovations in a sleek new design.
* Save up to 10% of the power from a 5 Watt module.
* Protection (PV & Battery), against short-circuit & reverse polarity, overload, over temperature & battery removal
* Can charge a completely discharged battery
* Regulation method: Low frequency On-Off series type (5% voltage drop)
* Typical set points: Off: 14.1 Volts On: 13.3 Volts (other set points available)
* Extreme design
* Series design (not shunt)
* Reliable - 100% solid state
* No radio interference
* Three LED status lights show solar on, battery charging, and battery full
* Wall mountable; stainless steel mounting screws provided
* Solid aluminum case, completely sealed in epoxy potting
* Dimensions: 9 x 14 x 4 cm; 500g
* Battery consumption zero, 0.0 mA
* Typical solar consumption 8mA daylight only, 3 mA without LED
* 5 year warranty
UK Delivery £3.95
|
| |
(Click to Enlarge)
|
Sunsei 25A controller (CC25000)
Highly reliable 12/24V, 25A charge controller, part of the Sunsei range. It will efficiently charge your batteries and provide years of protection from overcharging, prolonging your battery life and reducing maintenance requirements.
* Suitable for 12V and 24V systems; automatic voltage detection
* adjusts battery voltage limits with temperature
* built-in battery voltage and charge function indicator by LED display
* Simple, rugged electronics, a low component count and 100% solid state control functions make this a highly reliable controller.
* Features two stage charging boost and float charge using pulse width modulation (PWM)
* Status LED indicates battery charging
* Reverse leakage protection prevents power loss at night
* Terminal Block. For sound and easy wire connections
* 57x70x28mm, 0.12kg.
UK Delivery £3.95
|
| |
|
|
|
